Descriptions:
The meter is fully in conformity with the
relevant technical
requirements of GBT17215.3212008 national standard and the IEC62053
international standard of grade 1 or level 2 singlephase energy meter,
which can directly and accurately measure active energy of the energy
consumption. It features high reliability, small volume, light weight, beautiful
appearance, advanced technology, and 35mmDIN standard
guide rail installation, etc.
Features:
The
meter is fully in conformity with the relevant technical
requirements of GBT17215.3212008 national standard and the IEC62053
international standard of grade 1 or level 2 singlephase energy meter,
which can directly and accurately measure active energy of the energy
consumption.
LCD display is 7+1 or 6+1meter shows the total power consumption.
It features high reliability, small volume, light weight, beautiful
appearance, advanced technology, and 35mmDIN standard
guide rail installation, etc.
It has good antielectromagnetic interference, low power consumption,
high precision, high overload, high stability, anti electricitystolen and long
life.
This table is suitable for the measurement of rated frequency 50 Hz or
60 Hz singlephase ac active electricity, used for fixed installation
indoors, apply to the environment temperature is 25 celsius ~ 55
celsius , relative humidity is less than 95percent , and in the air does not
contain corrosive gases and avoid dust, mold, salt fog, condensation,
insects, etc.
Specifications:
Model: DDS5188
Phase number: single phase
Type: guide type
Display mode: LCD
Rated voltage: 220V
Rated current: 525A
Working temperature: 25 celsius ~ 55 celsius
Rated frequency: 5060Hz + 10percent
Accuracy level: level 1 (equivalent to measurement error < 1percent )
Including S0 port 2000ImpkWh (ti = 80ms)
Relative humidity: 95percent
Size: as the picture
Weight: 97g
Wiring:
Test:
The meter has photoelectric coupling type electric pulse test output
port, located in terminal button box (as shown in figure 2), + 5 VDC
of the test equipment connected to 20" + "terminal, signal S connected
to 21"" terminal.
Installation considerations:
1. Installation of electric meter required experienced electrician or professionals.
2.Electric meter should be installed in indoor ventilated and dry place, adopt 35mm DIN standard guide type installation,
the bottom plate of the electric energy meter shall be fixed to the rigid refractory, nonvibrating wall.
3.The bottom plate of the electric energy meter shall be fixed to the rigid refractory, nonvibrating wall.
4. Electricity meters should be installed in protective cabinets in places where there are filth and potential damages.
5.
The installation should be in accordance with the wiring diagram,
preferably with a multistrand copper wire, avoiding the abnormal or
burning of the electricity meter because of the bad contact.
6. When the electricity meter is correctly connected to the power grid, the power indicator of the meter is on
7.
Electric meter should take the lightning protection measures
when it is used in the area with more lightning, so as to avoid damaging
the electric energy meter by lightning.
The load capacity of the electricity meter is 0.05Ib~Imax (direct access)
Power indication: when the green light on, indicates that working power supply is normal
Pulse indication: when the red light on, indicates that the power pulse is detected
When there is a sampling signal, the pulse light is about 80ms
Package Included:
1 x DDS5188 Dinrail Kwh Meter
The meter is fully in conformity with the relevant technical requirements of GBT17215.3212008 national standard and the IEC62053 international standard of grade 1 or level 2 singlephase energy meter, which can directly and accurately measure active en
LCD display is 7+1 or6+1meter shows the total power consumption
It features high reliability, small volume, light weight, beautiful appearance, advanced technology, and 35mmDIN standard guide rail installation, etc
It has good antielectromagnetic interference, low power consumption, high precision, high overload, high stability, anti electricitystolen and long life
This table is suitable for the measurement of rated frequency 50 Hz or 60 Hz singlephase ac active electricity, used for fixed installation indoors, apply to the environment temperature is 25 celsius ~ 55 celsius , relative humidity is less than 95percent , and in the air does no
