Product name: CNC battery charging control module
Product model: XH-M603
Input voltage: DC10~30V
Control current: 20A max
Control accuracy: 0.1V
Output type: direct output
Voltage error: ±0.1V
Scope of application: 12~24V various storage batteries
Product net weight: 40g
Product size: 82*58*18mm
note:
If it doesn't display when connected, then you may not have connected the battery!
It must be connected to the battery to work normally, if the motherboard cannot detect the battery, it will not work;
Battery charging usually uses slow charging, that is, the charging voltage is about 1.2 times the rated voltage, and the charging current is about 1/10 of the rated capacity of the battery. For example: The charging voltage of a 12V 50AH battery is 14.4 volts and the charging current is 5A.
Using Method:
1.Set Starting Voltage:in normal display voltage state,press the button will display start charging voltage;long press for 3s the digital tube will flash;you can start or stop button to set starting up charge voltage value
2.Set Stop Voltage:in normal display voltage state,press the button will display stoping charge voltage;long press the button for 3s the digital tube will flash;you can start or stop button to set stoping charge voltage value
3.Factory Reset:in power on state press the start/stop button at the same time,digital tube will display 888;that represents factory reset settings
Package:
1 x DC12V-24V Lithium Battery Charge Control Protection Board /w LED Display XH-M603
